Evolis Avansia Guide de l'utilisateur télécharger pdf (Page 14)

Fitting the ink ribbon

To t a ink ribbon in the printing module, please proceed as follows:

Open the front cover.

Remove the ink ribbon cassette.

Load new ink ribbon in the cassette. Insert the spool spindle into the feed site (purple) holder. Unwind and load into the

shaft as shown. Finally, insert the spool spindle into the winding side holder, inserting the bottom first.

Take up the ink ribbon slack. Turn the wheel as shown and take up the ribbon slack.

Insert the ink ribbon cassette until a «click» is heard.

Put the Evolis electronic key in the key holder like shown page 13.

Close the front cover.

Press the SET Key, when [Push SET Key] appears on the LCD.

When placing the ink ribbon down, prevent contamination adhering by placing it with the handle of the bottom.

If the ribbon is cut, carefully cut the ribbon with scissors. Use cellophane tape to join the ribbon. Then go back

to the step

Ê Ë



1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 80 81

Pas de commentaire

Evolis Avansia Guide de l'utilisateur Page 14